ASSEMBLY AND SET-UP
4
Attaching the Steering Wheel
Required Tool:
5 mm Allen Wrench
Attaching the Seat
Required Tool:
5 mm Allen Wrench
1
Using a 5 mm Allen wrench,
loosen and remove the screw
located in the steering column.
1
Position the seat over the frame
and align it with the holes in the
frame.
2
Insert the screws and tighten
securely with a 5 mm Allen wrench.
Note:
Lap belt does not
require assembly.
2
Make sure wires are not tangled.
Insert the steering wheel, washer
and screw into the steering column
as shown.
4
Tighten the screw on the side of
the steering wheel securely with a
5 mm Allen wrench.
3
Tighten the screw above the
steering wheel securely with a
5 mm Allen wrench.
WARNING:
Failure to
properly install and tighten the
screws, nuts and bolts that affix the
steering wheel and seat can cause
you to lose control and crash.
WARNING:
DO NOT flip
the Ground Force upside down to
tighten the steering axle bolts as it
may damage control wires from the
steering wheel.
WARNING:
The lap belt
arrangement supplied with the
Ground Force is for “play” use only.
It is not an ASTM-approved lap
belt system and is not intended
to function as an approved lap/
shoulder/seat restraining device.
Summary of Contents for Ground Force
Page 2: ......