7
CHARGING THE BATTERY
Charger
Note:
Charger design may vary from
one shown
2
Note:
Make sure power button is
in the
OFF
position. Plug the charger
into the charger port. The light on
the charger should turn red during
charging. The light will turn green
again when charging is complete.
1
Plug the charger plug into wall
outlet. The light on the charger
should be green.
Note:
If green light (LED) does not
turn on, try a different outlet.
Your electric scooter may not have a fully charged battery; therefore you must charge the battery prior
to use. Be sure to charge the battery in a clean, dry location away from direct sunlight, flames or sparks.
• Initial charge time: 6 hours.
• Recharge time: up to 6 hours, even if the light turns
green. Recommended maximum charging time is
24 hours.
• Always charge the battery immediately after riding.
• Fully charge battery before storing for extended
periods of time.
• Unplug charger from the wall outlet when not in use.
• Failure to recharge battery periodically may result in a
battery that will not accept a charge.
• Make sure the power is turned OFF when product
is not in use. If the ON/OFF button is left on for an
extended period of time, the battery may reach a
stage at which it will no longer hold a charge.
• Run time: Up to 50 minutes of continuous ride time.
Run time may vary depending on riding conditions,
rider weight, climate, and/or proper maintenance.
• Constant starting and stopping may shorten ride time.
• Battery life can vary depending on proper
maintenance and usage of the product.
• Do not charge at or below 32°F (0°C).
Note:
If your charger does not look
like the one illustrated, your unit
has been supplied with an
alternative charger. The
specifications and charging
procedure would not change.
WARNING:
Use ONLY
with the recommended charger.
Batteries are only to be charged
under adult supervision. The charger
is not a toy. Always disconnect the
charger before wiping down and/or
cleaning the electric scooter with a
damp cloth.
The charger supplied with the
electric scooter should be regularly
examined for damage to the cord,
plug, enclosure and other parts.
In the event of such damage, the
electric scooter must not
be charged until it has been
repaired or replaced.
Chargers have built-in overcharge
protection to prevent battery from
being overcharged.
Be sure to properly align the groove
on the charger input plug with the
corresponding socket on the case;
otherwise, no charging action will
occur.
Note:
If the charger gets warm
during regular use, this is a normal
response and is no cause for
concern. If your charger does not get
warm during use, it does not mean
that it is not working properly.
Wall outlet - Green (stand by)
Wall outlet and unit - Red (charging)
Wall outlet and unit - Green
(charged)
Note:
Continue charging unit even if
light turns green prior to 6 hours.
WARNING:
Battery charge
can deplete over time. Periodically
recharge battery when not in use.
7
Model
Voltage
(Nominal) Vdc
Capacity
(Nominal) Ah
Charge
Temperature Range
Operating
Temperature Range
EcoSmart Cargo
46.8
7.6
0° to 40°C
32° to 104°F
-20° to 40°C
-4° to 122°F
Need Help?
Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at
www.razor.com
. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer
Service contact information is listed at the back of this manual.
Summary of Contents for ECOSMART CARGO
Page 2: ......
