Razor DUNE BUGGY, Owner'S Manual

Page: 3 / 30

BEFORE YOU BEGIN
2
WARNING: DO
NOT USE NON-RAZOR
PRODUCTS WITH YOUR
RAZOR DUNE BUGGY.
The Dune Buggy has been built to
certain Razor design specifications.
The original equipment supplied at
the time of sale was selected on
the basis of its compatibility with
the frame, fork and all other parts.
Certain aftermarket products may
or may not be compatible.
q
Required Tools
Some tools may be supplied; however, we recommend the use of mechanic’s grade tools. Use the supplied tools only
as a last resort.
Need Help?
Visit our web site for replacement parts, product support, live chat and a list of
authorized service centers at www.razor.com or call toll-free at 866-467-2967 Monday - Friday
8:00 AM - 5:00 PM Pacific Time.
2.5mm hexagonal wrench
(included)
Bicycle-style tire pump
for Schrader valve tires,
with pressure gauge
ASSEmBLY AND SET-UP
q
Charging the Battery
Your Dune Buggy may not have a fully charged battery; therefore you must charge the battery prior to use.
• Initial charge time: 12 hours • Run time: up to 40 minutes
• Recharge time: up to 8 hours • Average battery life: 250 charge/discharge cycles
• Fully charge once a month when not in use • Do not store below 32 degrees - this can damage the battery.
1
Plug the charger port into
the port on the Dune Buggy. The
charger works with the power
switch in either the on or off
position.
2
Plug the charger plug into a
wall outlet.
WARNING:
Rechargeable batteries are only to
be charged under adult supervision.
Always disconnect your Dune
Buggy from the charger before
cleaning with liquid.
Note:
If your charger does not
look like the one illustrated,
your unit has been supplied
with an alternative charger.
The specifications and charging
procedure would not change.
The charger has a small window
with one LED or two LEDs to
indicate the charge status. Refer
to the illustration on the charger
unit for the actual “charging” and
“charged” status indications for
your model charger.
Chargers have built-in over-charge
protection to prevent battery from
being over-charged.
Be sure to properly align the
groove on the charger input
plug with the corresponding
socket on the case; otherwise,
no charging action will occur.
Charger
Plug
Charger
Port
1
Use the 2.5mm hexagonal
wrench to make a throttle
adjustment.
q
Adjusting the Throttle