3
Speed Control
Drive
Chain
Front Fork
Brake Lever
Brake Lever
Brake Lever
Remove contents from box. Remove the separators that protect the components from damage during shipping. Inspect the
contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping. Because the motor
bike was 95 percent assembled and packed at the factory, there should not be any problems, even if the box has a few scars or
dents.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult with experience in bicycle mechanics.
Allow up to 30 minutes for assembly, not including initial charge time.
Allow up to 12 hours for charge
(see page 7 for charging information).
WARNING:
DO NOT USE
NON-RAZOR PRODUCTS WITH
YOUR RAZOR ELECTRIC MOTOR
BIKE. The motor bike has been built
to certain Razor design specifications.
The original equipment supplied at
the time of sale was selected on the
basis of its compatibility with the
frame, fork and all other parts. Certain
aftermarket products may not be
compatible and will void the warranty.
Required Tools
5 mm and 6 mm
Allen wrenches
10 mm, 14 mm and 17 mm
wrenches
(MX500/MX650 Models)
10 mm, 17 mm and 19 mm
wrenches
(SX500 Model)
Phillips screwdriver
Spoke tightener
Charger
(Note: Charger design may vary from
one shown)
Product ID Locations:
See locations to the left
1. Battery cover
2. Frame (underneath unit)
3. Charger
4. Box - side of UPC (not shown)
Plastic Bag Contents:
• Charger
• Handlebar Clamps
• Front Axle Bolt
• Tools
• Owner’s Manual
1.
2.
3.
BEFORE YOU BEGIN
Summary of Contents for Dirt Rocket MX500
Page 2: ......
