4
q
Charging Battery
Charge battery prior to use.
• Initial charge time: 18 hours
• Run time: Up to 30 minutes of continuous ride time
• Recharge time: up to 12 hours,
• Average battery life: 250 charge/discharge cycles
depending on the level of depletion
warnIng:
Always disconnect your electric
motorbike from the charger
before cleaning with liquid.
Note:
If your charger does not
look like the one illustrated,
your unit has been supplied
with an alternative charger.
The specifications and charging
procedure would not change.
The charger has a small window
with one LED or two LEDs to
indicate the charge status.
Refer to the illustration on
the charger unit for the actual
“charging” and “charged”
status indications for your
model charger.
Chargers have built-in
protection to prevent battery
from being over-charged.
Be sure to properly align the
groove on the charger input
plug with the corresponding
socket on the case;
otherwise, no charging
action will occur.
Charger
Plug
Charger
Port
asseMBly anD seT-up
1
Turn power
OFF
before
charging.
2
q
attaching number plate
1
Thread the brake lever
adjuster in or out 1/4 to 1/2
turn until the desired brake
adjustment is attained. If brake
still needs further adjustment,
proceed to step 2.
2
If the brake has too much
slack, loosen the brake anchor
cable for additional adjustment.
warnIng:
The brake is capable of
causing the electric motorbike
to skid the tire throwing an
unsuspecting rider. Practice
in an open area free from
obstacles until you are familiar
with the brake function. Avoid
skidding to a stop as this can
cause you to lose control or
damage the rear tire.
repaIr anD MaInTenanCe
Turn power “OFF” before conducting any maintenance procedures.
q
adjusting Brakes
