razberi technologies
™
50
the trigger active until the event stops. Set the Image frequency as the
upload frame rate. The setting range is from 1 frame to 15 frames.
NOTE:
Make sure FTP configuration has been completed. Refer
to
FTP
for further details.
Upload Image by E-Mail
Select this item and the Administrator can assign an e-mail address and
configure various parameters. When motion is detected, event images
will be sent to the appointed e-mail address.
<Pre-trigger buffer> function allows users to check what happened to
cause the trigger. The <Pre-trigger buffer> frame rate could be
pre-determined.
On the other hand, <Post-trigger buffer> is for users to upload certain
amount of images after the motion event occurs.
Check the box <Continue image upload> to upload the triggered images
during certain time or keep uploading until the trigger is off. Select
<Upload for __sec> and enter the duration in the blank. The images of
the duration will be uploading by E-mail when the motion event occurs.
The setting range is from 1 to 9999 seconds. Select <Upload during the
trigger active> to make the images keep being uploaded to E-mail
during the trigger active until the event stops. Set the Image frequency
as the upload frame rate. The setting range is from 1 frame to 15
frames.
NOTE:
Make sure SMTP configuration has been completed.
Refer to
for further details.
Send HTTP notification
Check this item, select the destination HTTP address, and specify the
parameters for event notifications by <Motion Detection> triggered.
When an alarm is triggered, the notification can be sent to the specified
HTTP server.
For instance, if the custom parameter is set as”
action=1&group=2
”, and
the HTTP server name is”
http://192.168.0.1/admin.php
”, the notification
