
2.9 Swing-Away Lateral Supports – All Models
The Raz Shower Chair may be fitted with optional lateral supports.
Lateral supports are designed to assist a user in maintaining an
upright posture in the Raz Shower Chair. One or two lateral supports
may be mounted on any Raz model. The molded foam pads have a
soft foam exterior, contoured to hug the torso, with a solid insert to
provide strength for positioning. An extension plate can be ordered as
an option to attain additional forward extension of the lateral support
pad. The lateral pads can be adjusted medially up to 1½” on both
sides of the chair for slighter individuals. The lateral supports can be
adjusted towards or away from the chair back within a range of 1”.
The lateral support pads can also be angled to meet the users’ needs.
Both lateral support pads lock facing forward and behind the backrest.
Raz AP/SP User’s Manual
20080509
11
To release a lateral support pad from the forward position:
1. Grasp one pad bracket at the blue arrow decal and lift up.
2. Once released, rotate the lateral pad to a position behind the
back and press down above the decal to lock the pad in place.
3. Repeat for the other lateral support if desired.
4. Check to ensure that the laterals are locked in place before
allowing the user to rest against them.
To release a lateral support pad from the rearward position:
1. Grasp the pad bracket near the mounting post and lift up.
2. Once released, rotate the lateral pad around to the front and
press down above the decal to lock the pad in place.
3. Repeat for the other lateral support if desired.
4. Check to ensure that the laterals are locked in place before
allowing the user to rest against them.
ALL ADJUSTMENTS TO LATERAL SUPPORT PADS (UP/DOWN, MEDIAL/ LATERAL, AND
ANGLE) MUST BE PERFORMED BY A QUALIFIED HEALTHCARE PROFESSIONAL. ALL
ADJUSTMENTS PERFORMED MUST NOT IMPEDE THE OPERATION OF OTHER COMPONENTS.
IMPORTANT !
2.10
Headrest – All Models
The optional headrest can be ordered with any Raz Shower Chair
model. The molded headrest is shaped to cradle the head comfortably
and is easy to clean. The headrest can be adjusted infinitely forward
and backwards within a 6½” range, and vertically within a 12½” range.
In order to adjust the headrest position:
1. Loosen the bottom triangular knob and adjust the vertical
“swan neck” bar to achieve headrest height adjustment.
2. Loosen the top triangular knob and adjust the headrest
horizontally for a fore/aft change in position.
3. To change the angle of the headrest itself, loosen
(do not
remove)
the three screws on the back of the moulded
headrest. Rotate the headrest around the end of the headrest
mounting bar to suit the users’ needs and tighten the screws to
secure the desired position.
4. Ensure that all knobs and screws are tightened securely for
the user’s safety.