To adjust the Leg Adductors:
1. Loosen the tri-lobe knob on the Leg Adductor clamp mounted
on the side of the chair frame.
2. Reposition the adductor pad to a height suitable for the user.
3. Tighten the tri-lobe knob
4. Repeat steps 1 to 3 for the other Leg Adductor if necessary.
To remove the Leg Adductors, loosen the tri-lobe knob and lift the
adductor out of the adductor clamp on the frame.
2.11
Armrests
The Raz Shower Chair comes standard with flip-up padded armrests. Also available are 3¼” Molded
Flat Armpads as an alternative to the standard 2¼” wide armpads. The armrests on Multi-Position Backs
are fixed at one height (8”) but are adjustable in angle (up to 10°).
ARMRESTS ON RAZ AP600 AND SP600 MODELS ARE NOT INTENDED TO SUPPORT THE
ENTIRE BODY WEIGHT OF AN INDIVIDUAL. TOO MUCH WEIGHT MAY CAUSE DAMAGE TO THE
ARMRESTS OR MAY CAUSE THE CHAIR TO TIP.
IMPORTANT !
2.12
Chest Positioning Strap
An optional one-piece Chest Positioning Strap can be attached to any
Raz Model. The 2” wide heavy-duty webbing can be used to support a
user in a forward leaning position for hygiene access to the user’s
back. The back upholstery includes loops that are intended as strap
guides.
To install the Chest Positioning Strap:
1. Insert one side of the strap through both back upholstery loops.
2. With the user seated in the chair, thread one end of the strap
through the plastic loop on the other end of the chest strap.
3. Secure the strap in front of the user with the Velcro closure.
To adjust the Chest Positioning Strap:
1. Open the Velcro on the strap.
2. Tighten or loosen the strap around the user as needed.
3. Fasten the chest strap to secure the user.
IMPORTANT !
ANY ADJUSTMENTS TO THE CHAIR’S STRAPS SHOULD BE PERFORMED WITH EXTREME
CAUTION AS THE USER’S SAFETY MAY BE DEPENDENT ON SECURE POSITIONING STRAPS.
Raz AP600/SP600 User’s Manual
20090122
12
