Raytech USA, Inc.
All rights reserved. No portion may be reproduced without written consent.
11
OPERATION:
7 – 0
WARNINGS!
BEFORE OPERATING THIS OR ANY OTHER TEST EQUIPMENT READ ALL SAFETY
WARNINGS AND UNDERSTAND THEM FULLY.
OPERATION:
This section describes a typical, step by step, operation of the WR50-12
Open the protection lid of the case and attach the test leads and the power cord to the test set.
The Two (2) connections on the front plate
+
Current &
-
Current are the current leads.
The Four (4) connections on the front plate
+
Channel
1 &
-
Channel 1 and
+
Channel
2 &
-
Channel 2 are the Potential or Voltage leads.
By connecting a test specimen to the Current leads and applying the potential leads across the
specimen the resistance readings will be determined.
GETTING STARTED:
7 – 1
Turn on the Power switch, located at the power input connector, to the “I” position.
The Initial screen will appear. The Instrument will also make the initial calibration.
After a few seconds the main screen will appear:
