Raytec PULSESTAR VTS Series, Installation Manual

Page: 16 / 38

6
Connecting the VTS
All connections to the VTS are made through an unterminated, screened 16
core cable. The length of this cable is either 2000mm or 3000mm depending
on what you specified. The terminations for the cable are explained in Section
6.1, Network connection.
6.1
Network connection
All connections are provided on a 16-core cable. The wire allocation depends
on the variant chosen. The connections are as follows:
Wire Colour Ethernet Function RS232 Function
Black
Blue
Power supply – Power supply –
Red
Red/Blue
Power Power
White Trigger in – Trigger in –
Brown Trigger in + Trigger in +
Grey Ethernet Tx + Not connected
Pink Ethernet Tx – TxD
Yellow Ethernet Rx + RxD
Green Ethernet Rx – GND
Grey/Pink Trigger out – Trigger out –
Violet Trigger out + Trigger out +
Yellow/White Not connected Not connected
Yellow/Brown Not connected Not connected
Green/White Not connected Not connected
Green/Brown Not connected Not connected
When installing your VTS, ensure you do not exceed the allowed bend radius for
the cable. For occasional flexing, this is 15 x outside diameter (or 155mm). For
fixed installation, the bend radius is 6 x outside diameter (or 62mm).
12