32
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1) this device may not cause harmful interference and
2) this device must accept any interference received, including interference that may cause
undesired operation.
Required End Product Labeling
Any device incorporating this module must include an external, visible, permanent marking or
label which states: “Contains FCC ID: SH6MDBT53V”
Applicable FCC Rules
This module has been tested and found to comply with the following requirements for Modular
Approval.
Part 15.247 - Operation within the bands 902-928 MHz, 2400-2483.5 MHz, and
5725-5850 MHz.
Additional testing, Part 15 Subpart B disclaimer
The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC
transmitter rules) listed on the grant, and that the host product manufacturer is responsible for
compliance to any other FCC rules that apply to the host not covered by the modular
transmitter grant of certification.
The final host product still requires Part 15 Subpart B compliance testing with the modular
transmitter installed.
Test Modes
This device
uses various test mode programs for test set up which operate separate from
production firmware. Host integrators should contact the grantee for assistance with test
modes needed for module/host compliance test requirements.
Antennas
The following external antenna type have been approved for use with this module.
Radio
Model
Antenna Type
Freq.
(MHz)
Max. Peak
Antenna
Gain (dBi)
BLE
MDBT53V
Chip
2402-2480
-1.35
BLE
MDBT53V-P
PCB
2402-2480
-2.26
In the end product, the antenna(s) used with this transmitter must be installed and must not
Summary of Contents for MDBT53V
