4
“OFF”
after completing laminating job. Otherwise It will seriously damage important
components inside machine.
HOW TO USE OPERATING MODE:
1-
There are nine operating modes in program setting. Except mode USE, the temperature
setting and thickness of pouch are associated and fixed. Please refer to THE TABLE OF
PROGRAM SETTINGS
2-
Each Pressing of Mode button (14) the mode changes, Mode Display (20) will display code of
mode, Press Mode button (14) constantly until Mode Display (20) showing the code of mode
expected. (If the pre-test laminating effect was not good enough, only can manually adjust
feeding speed to get better laminating effect (press button (11) or (12) to adjust).
Caution:
There’s no reaction by pressing button (16) and (17) except in USE mode.
3-
Mode “USE” is a special mode which is called USER-DEFINED. Temperature (button (16) and
(17)) and feeding speed (button (11) and (12)) can be adjusted as needed.
COLD LAMINATING OPERATION:
Caution:
Only use self-adhesive pouches when laminating with COLD mode.
1-
Follow Operation Steps 1 and 2.
2-
Press Power Switch (01) to “
ON
” , and Power Indicator (22) blinking
. Press Switch button
(13) to activate machine, and the Power Indicator (22) changes from blinking to
illuminating . In the meanwhile, all information displays on the Operation Panel. Actually
this information shows working status of last time before power off.
3-
Press Mode button (14) to select mode
“COL”
. Operating laminating job after Laminating Light
(23)
illuminating. (
Caution:
Please refer to
HOW TO USE OPERATING MODE
)
4-
If the machine had been used in any
HOT
mode, it will need to wait approximately 45-60
minutes for cooling down. Always operating laminating job after Laminating Light (23)
illuminating .
WARNING:
Failure to do this may damage machine.
5-
Center item on clear side against sealed edge; document cannot be repositioned once
laminated.
6-
Peel a small part of the protective sheet away from document.
7-
Place pouch, sealed edge first, into Pouch/Document Entry (10) for laminating. Keep pouch
straight and continue peeling the protective sheet away.
8-
The finished laminating item will automatically exit the rear of machine.
9-
Follow Operation Steps of HOW TO TURN OFF MACHINE, and unplug after completion of
usage.
MAINTENANCE AND CLEANING:
The adhesive could exude onto the rollers during laminating, it’s normal phenomenon. To keep
your laminator free of adhesives that could hurt the quality of your work,
clean the rollers
regularly:
1-
Follow HOT LAMINATING OPERATION steps 1 and 2, select code of mode “
150
”.
2-
Wait for Laminating Light (23)
to illuminate.
3-
Insert a cleaning sheet ( we recommend to use a Kraft paper or a paper binding cover with
leather board surface), repeating five to six times.
4-
Insert a plain white sheet of paper to test for remaining traces, and reinsert the cleaning sheet,
if necessary, and retest.
5-
To clean the exterior of the machine, wipe with a soft cloth dampened with tap water.
