2
11- Speed Up button 12- Speed Down button 13- Switch button 14- Mode button 15-
Reverse button 16- Temp. Down button 17- Temp. Up button 18- Temp. Display
19- Speed Mode Display 20- Mode Display 21- Motor Running indicator 22- Power Indicator
23- Laminating Light 24- Moving forward indication 25- Moving backward indication 26-
Temp. Up Indication 27- Temp. Down Indication 28- Temperature Indicator
29- Wait Indicator
OPERATION STEPS:
1-
Place the machine on a sturdy, flat work surface. Allow ample clearance behind the machine
for laminated items to exit completely.
2-
Plug the machine into a power source that matches the machine’s rate of voltage.
HOT LAMINATING OPERATION:
1-
Press Power Switch (01) to “
ON
” , and Power Indicator (22) blinking
. Press Switch button
(13) to activate machine, and the Power Indicator (22) changes from blinking
to
illuminating . In the meanwhile, all information displays on the Operation Panel.
NOTE:
During first usage, a small white puff of smoke may appear which is common to a new
laminator.
2-
Press Mode button (14) to select correct code of mode. (
Caution:
Please refer to
HOW TO USE
OPERATING MODE
)
3-
Wait for a few minutes until “WAIT” indicator (29) off and Laminating Light (23)
illuminating. This indicates the machine is ready for use. (
Caution:
At the beginning, please
wait a little long time and operate after Laminating Light (23)
to illuminate at second
time. It can get more perfect effect of laminating). Please pre-test laminating effect before
formal operation. If the result of pre-test was not satisfied, press Speed up button (11) or
Speed down button (12) to adjust feeding speed.
NOTE:
There’s no reaction by pressing button
(16) and (17) during the operating mode in the status of normal Program Settings. They only
can be manual adjusted under the Mode “USE” (Please refer to THE TABLE OF PROGRAM
SETTINGS)
4-
Place item to be laminated into a pouch against the sealed edge. Center the item for an even
border, a border of approximately 3-5 mm is recommended.
