2
99
Dynamic
Modes
29 Static Colors
Unit
Length
Adjustable
Static
Brightness
Adjustable
Speed
Adjustable
6
3
4
5
10
+
-
1
2
7
8
9
USER
'
S
MANUAL
Card Type RF Remote
Ultra Slim Design
Loop Demo Mode
Drive up to 800 Pixels
Power off Memorize
1. Power Input
The power supply input.
and sleeve is negative. Also please make sure the power
supply voltage is same as the LED load.
The DC jack’s inner pole is positive
2. Signal Output
The control signal output connector to LED load.
3. Mode Adjust
Adjust running mode. Jump to next mode by press ‘MODE+’ or
jump to previous mode by press ‘MODE-’.
Functions
4. Speed (Brightness) Adjust
Adjust the running speed of dynamic mode or brightness of
static color. There are 10 levels for both speed and brightness.
5. Pause / Play
Toggle between Play and Pause mode. It will quit pause and
start to play if changing the running mode.
6. Turn On / Standby
Turn on or switch to standby mode. The main unit will
memorize the current setting. When power on or turn on unit,
it will automatically restore to previous status.
7. Unit Length (Static Color) Adjust
Adjust playing unit length at dynamic modes or adjust color at
static color mode. At static color mode, press these keys to loop
chang
olors.
8. Program direct selecting keys
User can directly select program by the number and Enter key
in this area. For example, if you want program number 58,
please press number 5 and 8, then press Enter key to confirm.
The program ‘0’ is static color mode. At this mode, user can
adjust brightness or color by SPEED and LENGTH keys.
9. Demo Mode
Switch to demo mode. In demo mode, the controller will
automatically cycle play 99 dynamic programs.
10. Remote Controller Indicator
This blue indicator will light up when remote controller works.
In program direct selecting operation, this indicator will flash
slowly until Enter key pressed or no operation for a certain
time.
Hints: The remote controller works at radio frequency, the
signal can pass through barrier, so it’s not necessary to aim at
the controller when operate the remote.
Installing
2. Output Signal
The output signal is in a SM type plug. The cable at the
' '
maker
side
is
power
supply
,
the
cable
sequence
is
power
-
data
-
clock
-
ground
.
The controll
signals
are
running
at
high
speed
,
led
may
not
work
properly
if
the
data
cable
is
too
long
or
get
interfered
.
In
This
case
,
please
shorten
the
data
cable
from
controller
to
LED
or
install
the
controller
close
to
LED
.
1. Power Supply
The power supply jack is a 5.5mm diameter DC socket. The
main unit can work at DC 5V to 24V. Since the power supply is
directly connected to the LED signal output, please make sure
the power voltage is same as the LED load, otherwise the
incorrect voltage may damage LED load!
When LED load is powered individually, the main unit can also
work with the LED load power, and the power supply to this
DC jack can be saved.
e 29 c
www.ledtechnologies.co.uk
