15
Programming - continued
Menu Structure
1. STEP 1
(Set Schedule)
a. Speed and Duration
2. STEP 2
(Set Schedule)
a. Speed and Duration
3. STEP 3
(Set Schedule)
a. Speed and Duration
4. OVERRIDE
(Settings)
a. Speed and Duration
5. START
Press START to run the pump based on the programmed 24 hour schedule. The schedule is based on a
24 hour cycle and will repeat each day of the week.
During operation the LED lights above the “SPEED” and “DURATION” will flip back and forth every three
seconds. When lit, the graph below will show the active programmed speed or duration in progress.
Note: The START button must be pressed for the pump to operate. The START LED will illuminate after
the button has been pressed.
Note: If the schedule times combined are less than 24 hours, the remaining time for the 24 hour cycle will
be filled with the motor stopped.
Restore Factory Defaults:
Press and hold the STOP and OVERRIDE key for 3 seconds. When the reset has been recognized the
Bar graph will blink three times.
Figure 4
Figure 5
