background image

2

CONTENTS

1. WARNINGS  .................................................................. 2
2.  WATER CHEMISTRY ................................................... 3
3.  SAFETY INFORMATION ............................................. 3
4. OVERVIEW ..................................................................... 3
5.  BEFORE INSTALLATION ............................................ 4
6. INSTALLATION ............................................................. 4
7.  WATER CONNECTION ................................................ 4

8.  FREEZE PROTECTION ................................................ 5
9.  ELECTRICAL CONNECTIONS ................................... 5
10. OPERATION .................................................................. 6
11. CONTROL ...................................................................... 7
12. REMOTE OPERATION ................................................. 8
13. TROUBLESHOOTING ................................................10
14. WIRING DIAGRAMS ..................................................11

WARNING:

 Do not use this heater if any part has 

been  under  water.  Immediately  call  a  qualified  service 

technician to inspect and replace the heater.

WARNING:

 To minimize the possibility of improper 

operation, serious personal injury, fire, or damage to the 

heater:

• 

Always keep the area around the heater free of 

combustible materials, gasoline, and other flammable 

liquids and vapors.

• 

Heater should never be covered or have any blockage 

to the flow of fresh air to the heater.

WARNING:

 Risk of electrical shock. More than one 

disconnect  switch  may  be  required  to  de-energize  the 

equipment before servicing.

1.  WARNINGS 

Pay Attention to these Terms

DANGER

Indicates the presence of immediate hazards which will cause severe personal injury, death or substantial 

property damage if ignored.

WARNING 

I

ndicates the presence of hazards or unsafe practices which could cause severe personal injury, death or 

substantial property damage if ignored.

CAUTION

Indicates the presence of hazards or unsafe practices which could cause minor personal injury or product or 

property damage if ignored.

NOTE

Indicates special instructions on installation, operation, or maintenance which are important but not related to 

personal injury hazards.

EFFICIENCY TESTING NOTICE:

 For purposes of verifying 

or  testing  efficiency  ratings,  the  test  procedure  in  Title 

10 APPENDIX P to Subpart B of Part 430 (Uniform Test 

Method for Measuring the Energy Consumption of Pool 

Heaters).

Revision 4 reflects the following changes:

Update WARNING to read "to inspect and replace the heater." on page 2.
Added "IMPORTANT SAFETY INSTRUCTIONS" and "SAVE THESE INSTRUCTIONS" on page 3.
Updated section 11 to read "Hold the knob for two (2) seconds..." on page 7. Updated digital control decals on page 7.
Remove the two sentences on top of Table G and updated the table heading-titles on page 9.

Summary of Contents for ELS 0005













Reviews: