Chapter 3: Installation
19
5. Place the keypad seal (9) in position on the keypad (i.e. so that the holes in the
seal accept the appropriate keypad buttons).
6. Place the assembled flush mount bezel and panel seal, in position on the
instrument, so that the rubber keys are correctly located in the holes on the
bezel, then clip the bezel and instrument together.
7. Using the four, self-tapping screws (12) provided, secure the instrument and
bezel together. Fit the screws from the rear of the instrument and tighten
them sufficiently to secure the instrument and bezel together. DO NOT OVER-
TIGHTEN.
Flush mounting procedure
Flush mount your instrument (see the
Flush mounting illustration) as follows:
1. Assemble the ST60+ instrument and flush mount bezel as described under
Fitting the flush mount bezel .
CAUTION: Use the correct screws
It is essential that only screws of the correct size are used to
secure the instrument to the bezel. Failure to observe this caution
could result in damage to both the instrument and the bezel.
Flush mounting
4
1
3
5
6
5
1
D8150-1
81262_2.book Page 19 Friday, November 11, 2005 11:11 AM
