Raymarine SmartPilot X-5R, Drive Installation & Setup

Page: 60 / 76

52 SmartPilot X-5R Drive Installation and Setup Guide
The default page settings are:
Setting up data pages
When setting up your data pages, we recommend that you:
•
Retain the BTW and DTW data pages. If your SPX-5R Drive system receives a
man overboard (MOB) message, these data pages will show the bearing and
distance to the MOB location.
• Disable data pages you do not need to NOT USED . These will then not be
displayed during normal operation, thereby improving the access time to the other
data pages..
.
Data Page Default Setting
1 XTE (Cross Track Error)
2 BTW (Bearing to Waypoint) - see Note below
3 DTW (Distance to Waypoint) - see Note below
4 RESPONSE
Remaining pages NOT USED (see Setting up data pages below)
Available Data Pages Displayed as
Speed Knots SPEED KTS
Log LOG XXXX .X
Trip TRIP XXX.X
Average Speed AV. SPD
Wind Direction e.g. WIND PORT
Wind Speed WIND KTS
Depth Metres DEPTH M - see Note below
Depth Feet DEPTH FT - see Note below
Depth Fathoms DEPTH FA - see Note below
Heading HEADING
Water Temperature, Degrees C WATER °C - see Note below
Water Temperature, Degrees F WATER °F - see Note below
Course Over Ground COG
Speed Over Ground, Knots SOG KTS
Cross Track Error XTE
Distance to Waypoint DTW