18
SmartPilot X-5 Sport installation & Setup Guide
9. Slide the steering wheel onto the stub shaft, so that the woodruff key inserted at
step 8 engages with the keyway in the wheel.
10. Place the original steering wheel washer on the shaft then secure the steering
wheel with the original wheel-securing nut.
11. Replace the wheel hub cover.
Fitting to 1 inch steering shaft
To fit the Sport Pilot drive to a 1 inch steering shaft, refer to the illustration above and:
1. Insert the smaller of the two woodruff keys supplied into the keyway on the
steering shaft. If necessary, use a small hammer to lightly tap the key into position
2. Slide the SPX-5 Sport Drive onto the steering shaft so that the woodruff key
inserted at step 1 engages with the keyway in the drive.
Note:
Do
NOT
use the original wheel nut and washer to secure the Sport Drive.
3. Place the
5
/
8
inch seal washer (supplied) on the shaft so that the seal side is
towards the Sport Drive.
4. Use the box spanner supplied to secure the drive unit with the
5
/
8
inch nylock nut
supplied.
5. With the steering still hard over to starboard, tighten the drive unit securing nut to
22 pound feet (30 Newton meters).
Woodruff
key (small)
Woodruff
key
(large)
Alignment
mark
Alignment
mark
Screw
Washer
Seal
washer
SportPilot
Taper
adaptor
Stub
shaft
Nyloc
nut
(small)
Nyloc nut
(large)
1" shaft
D10670-1
1 inch shaft fitting
87076_1.book Page 18 Monday, March 10, 2008 9:21 AM
