Raymarine SeaTalk, Owner'S Handbook Manual

Page: 23 / 36

Chapter 4: Setup 11
4. Press the key to select another instrument and repeat the procedure in
step 3.
5. Repeat the procedure in steps 3 and 4 until all instruments in the group have
been identified.
Note: If you have more than eight standard instruments, a second group, operated by an-
other Remote Keypad, must be created. The identification code for additional Keypads and
instruments would for example, be B1, B2 etc.
6. Assign a Remote Keypad to the required group as follows:
i. Use the or key to select any instrument in the required group.
ii. Press the and keys together for 1 second. Depending on the type
of instruments you are grouping, the following messages are displayed
on the instruments with the same group letter.
iii. At the Remote Keypad, press any one of the keys dedicated to the stan-
dard instruments, to assign the Remote Keypad to the selected instru-
ment group.
7. If you are creating more than one group, repeat the procedures described in
steps 2 to 6.
Group setup indications - allocating keypad
D2784-3
Typical ST60 digital Typical ST60 analogue ST60 Tridata
Typical ST80 digital
Typical ST80 analogue
81073_6.book Page 11 Thursday, March 2, 2006 2:39 PM