Raymarine RVX1000, Installation Instructions Manual

Page: 11 / 108

• Raymarine specified cables are used.
• Cables are not cut or extended, unless doing so is detailed in the installation manual.
Note: Where constraints on the installation prevent any of the above recommendations , always
ensure the maximum possible separation between different items of electrical equipment, to
provide the best conditions for EMC performance throughout the installation
Compass safe distance
To prevent potential interference with the vessel's magnetic compasses, ensure an adequate
distance is maintained from the product.
When choosing a suitable location for the product you should aim to maintain the maximum possible
distance from any compasses. Typically this distance should be at least 1 m (3 ft) in all directions.
However for some smaller vessels it may not be possible to locate the product this far away from a
compass. In this situation, when choosing the installation location for your product, ensure that the
compass is not affected by the product when it is in a powered state.
Declaration of Conformity
FLIR Belgium BVBA declares that the RVX1000 Sonar module, part number E70511, is in compliance
with the EMC Directive 2014/30/EU.
The original Declaration of Conformity certificate may be viewed on the relevant product page at
www.raymarine.com/manuals .
Connections to other equipment
Requirement for ferrites on non-Raymarine cables
If your Raymarine equipment is to be connected to other equipment using a cable not supplied by
Raymarine, a suppression ferrite MUST always be attached to the cable near the Raymarine unit.
Product disposal
Dispose of this product in accordance with the WEEE Directive.
The Waste Electrical and Electronic Equipment (WEEE) Directive requires the recycling of waste
electrical and electronic equipment which contains materials, components and substances that may
be hazardous and present a risk to human health and the environment when WEEE is not handled
correctly.
Equipment marked with the crossed-out wheeled bin symbol indicates that the equipment
should not be disposed of in unsorted household waste.
Local authorities in many regions have established collection schemes under which residents can
dispose of waste electrical and electronic equipment at a recycling center or other collection point.
For more information about suitable collection points for waste electrical and electronic equipment in
your region, refer to the following table:
Region Website Region Website
AT www.araplus.at IT www.erp-recycling.org/it-it
BE www.recupel.be LT www.eei.lt
BG www.greentech.bg LU
www.ecotrel.lu , https://aev.gou-
vernement.lu/fr.html
CY www.electrocyclo-
sis.com.cy LV www.lze.lv
CZ www.retela.cz MT http://www.greenpak.com.mt
Important information
11