Raymarine RS150, Installation Instructions Manual

Page: 24 / 48

5.1 Surface mounting
The unit can be mounted on a surface that is up to
28 mm (1.10 in) thick, approximately . To mount on a
thicker surface longer studs will be required.
D13546-1
1. Ensuring correct orientation, affix the supplied
mounting template to the mounting surface at the
desired location.
2. Drill 3 x fixing holes and 1 x cable hole using drill
bits of the size indicated on the template.
3. Place the waterproof gasket into position on the
underside of the receiver.
4. Connect the supplied cable to an available
SeaTalk ng spur connection.
5. Route the other end of the cable through the
cable hole and connect to the unit.
6. Screw the threaded studs into the underside
of the receiver unit (these should be hand-tight
only).
7. Position the unit so that the mounting studs pass
through the holes in the mounting surface.
8. Secure the unit to the mounting surface using the
thumb nuts provided. (these should be hand-tight
only).
5.2 Pole mounting
The unit can be mounted using the optional Pole
Mount Adaptor (A80370).
Pole mounting requires a Pole with a 1 inch 14 TPI
thread:
D13548-1
5
4
3
1
2 b
2 a
1. Attach the Pole Mount Adaptor to the top of the
pole.
2. Feed the supplied cable through either:
• 2a) the center of the Pole Mount Adaptor and
Pole, or
• 2b) the cable exit hole.
3. Connect the supplied cable to an available
SeaTalk ng spur connection and then connect the
other end of the cable to the connector on the
unit and secure using the locking collar.
4. Ensuring correct orientation, Secure the unit
to the Pole Mount Adaptor using the fixings
provided.
5. Fix the unit’s orientation by tightening the grub
screws provided.
Note: The Pole Mount Adaptor may also be used
to rail mount the unit using a 3rd party rail clamp
with a 1 inch 14 TPI thread.
24
RS150 Installation instructions