Upgrade Instructions
5
Assembly
1. Insert the new EPROM (14) into the socket. Make sure that the
EPROM is correctly orientated and all the legs are located
properly.
2. Apply heat sink compound (15) to the area of the case where the
insulation strip (3) fits. Apply double sided sticky tape (16) to the
case and attach the insulation strip as shown. Bend the strip over
the edge and apply a second layer of heat transfer compound.
3. Fit the location comb (4) into the upper case (2) with the two M2
screws (5). Do not tighten the screws at this stage.
Note: Check that the location comb has the new shape as shown.
If not, use Course Computer Modification Kit (part number:
Q098) to replace the old shape comb with a new shape comb.
1
2
3. Insulation strip
4. Location comb
15. Heat sink compound
16. Double sided sticky tape
3
4
D3103-1a
Old shape
3
15
16
2.5 mm hexagon key
15
New shape
4
85017_2.book Page 5 Monday, July 16, 2001 3:05 PM
