1
Splash-proof dust cap with lanyard
2
Mounting plate fixings x 3
3
Mounting plate nut
4
Mounting plate
5
Mounting plate gasket
6
Extension cable
1. Check the selected location for the Mounting plate, a clear flat
area is required.
2. Using a pencil, offer up the Mounting plate to the desired
location and mark the location of the screw holes and the
center hole on the mounting panel.
3. Drill the mounting holes using a suitable size drill bit.
4. Drill the center hole using a 25 mm (1 in.) hole cutting saw.
5. Pull the connector end of the cable through the hole in the
mounting surface.
6. Place the Mounting plate gasket over the end of the connector.
7. With the recessed side facing away from the mounting panel,
place the Mounting plate over the end of the connector.
8. Place the lanyard end of the Splash-proof dust cap over
the connector, ensuring the lanyard sits in the recess in the
Mounting plate.
9. Place the Mounting plate nut over the connector and tighten
clockwise using a 13/16 in. (21 mm) socket wrench, being
careful not to damage the plastic nut by overtightening.
10. Secure the Mounting plate to the mounting surface using the
supplied screws.
11. Attach the Handset / Fistmic connector to the cable connector
and rotate the locking collar clockwise to secure.
12. Connect the opposite end of the cable to the required
connector either on the Base station or to another pass-through
panel mounting plate connector.
Note:
Drill bit, tap size and tightening torque is dependent on
the thickness and type of material the unit is to be mounted on.
Operation instructions
For operation instructions for your handset, refer to the
documentation that accompanies your Radio.
All product documentation
is available to down-
load from the Raymarine
website:
• Ray60 / Ray70 Installation
and operation instructions
document number: 81356
• Ray90 / Ray91 Installation
and operation instructions
document number: 81377
Technical specification — Wired handset
(Raymic)
The following technical specifications apply to the Wired handset.
Operating temperature
-25ºC (-13ºF) to +55ºC (131ºF)
Storage temperature
-25ºC (-13ºF) to +70ºC (158ºF)
Relative humidity
95%
Water proofing
IPx6 & IPx7
Max speaker power
output
1 W (16 Ω)
VHF radio compatibility
• Ray60
• Ray70
• Ray90 / Ray91
4
Raymic wired handset installation instructions
