Pass-through panel kit mounting
When installing the Fistmic or the optional Raymic
handset, the pass-through panel kit should be used to
secure the cable to any panels the cable has to pass
through.
1
Splash-proof dust cap with lanyard
2
Mounting plate fixings x 3
3
Mounting plate nut
4
Mounting plate
5
Mounting plate gasket
6
Extension cable
1. Check the selected location for the Mounting plate, a
clear flat area is required.
2. Using a pencil, offer up the Mounting plate to the
desired location and mark the location of the screw
holes and the center hole on the mounting panel.
3. Drill the mounting holes using a suitable size drill bit.
4. Drill the center hole using a 25 mm (1 in.) hole cutting
saw.
5. Pull the connector end of the cable through the hole
in the mounting surface.
6. Place the Mounting plate gasket over the end of the
connector.
7. With the recessed side facing away from the
mounting panel, place the Mounting plate over the
end of the connector.
8. Place the lanyard end of the Splash-proof dust cap
over the connector, ensuring the lanyard sits in the
recess in the Mounting plate.
9. Place the Mounting plate nut over the connector and
tighten clockwise using a 13/16 in. (21 mm) socket
wrench, being careful not to damage the plastic nut
by overtightening.
10. Secure the Mounting plate to the mounting surface
using the supplied screws.
11. Attach the Handset / Fistmic connector to the cable
connector and rotate the locking collar clockwise to
secure.
12. Connect the opposite end of the cable to the
required connector either on the Base station or
to another pass-through panel mounting plate
connector.
Note: Drill bit, tap size and tightening torque is
dependent on the thickness and type of material the
unit is to be mounted on.
Raymic handset cradle mounting
Before mounting the unit, ensure that you have:
• Selected a suitable location, ensuring there is nothing
behind the mounting surface that may be damaged
when drilling.
• Identified the cable connections and route that the
cables will take.
1. Check the selected location for the mounting cradle,
a clear flat area is required, with sufficient space
around it to place and remove the Handset.
2. Using a pencil, offer up the cradle to the desired
location and mark the location of the screw holes
on the mounting surface.
3. Drill the mounting holes using a suitable size drill bit.
4. Hold the cradle in place and secure using the screws
provided.
5. Place the Handset into the cradle until it clicks into
position.
Passive speaker mounting
Follow the steps below to mount the Passive speaker.
Before mounting the Passive speaker ensure that you
have:
• selected a suitable location (a clear, flat surface is
required).
• identified the location for additional components, such
as the Handset or Base station etc.
• identified the relevant cable connections and the
route that the cables will take.
• removed the bezel.
23
81377-1-en_US_PRINT.pdf 23
12/21/2017 9:05:36 PM
