1) Own Ship’s ID Entry(Own Ship’s MMSI Entry)
To operate the RAY53 in the DSC mode,Own Ship’s ID must be registered in advance. The
registration procedure is as follows.
1. * If the former ID has been entered, Own Ship’s ID cannot be entered and Alarm 2 is
heard. There should be no MMSI number in the unit when shipped.
It is necessary for re-enter Own ship’s ID to delete the former ID by Own Ship’s ID
Clear.
*If there is no former ID, Alarm 1 is heard and Own Ship’s ID can be entered.
2. To enter DSC setting mode, press and hold the SCAN/MEM and WX/INT keys
simultaneously for 2 seconds.
----
Æ
“DSC” is displayed, which means the unit is in DSC mode.
----
Æ
“MEM” is displayed, which means OwnShip’s MMSI can be entered in DSC
mode.
3. MMSI number can be put by the following operation
-. “0” is displayed at Channel Display(Large) on the LCD and “1” is displayed at
Channel Display(Small) on the LCD.
Channel Display(Large) is representative the MMSI number itself and Channel
Display(Small) is representative of the position in the 9 digit.
-. When the Channel Selection knob is rotated, Channel Display(Large) shows the
MMSI number is increased/decreased as “0” base.( 0 to 9 can be selected)
-. MMSI number is selected by knob being rotated. When DSC key is pressed,
the audible beep sound 1 is heard and the selected number can be memorized.(“2” is
displayed at Channel Display(Small) on the LCD which means that 2
nd
(second) digit is
ready to be input. And the rest of the digits are entered in the same manner.
-. Once all of the digits have been entered, the unit will redisplay ID numbers every
1 second.
-. If the number was entered incorrectly, the customer perform the entry again by
pressing and releasing DSC key. At that time “0” is displayed at Channel
Display(Large) and “1” is displayed at Channel Display(Small).
