Mounting diagram
Note:
The illustration above depicts mounting of a p70Rs. The mounting procedure for the p70s and
p70Rs are the same.
Mounting instructions
1. Ensure the selected location meets the location requirements found here:
p.18 — General location requirements
2. Check the selected location for the display, a clear, flat area with suitable clearance behind
the panel is required.
3. Remove the bezel and buttonpad from the display.
4. Fix the supplied mounting template to the selected location, using self adhesive tape.
5. Drill the cut out hole using a 92 mm (3 5/8”) hole cutter.
Alternatively, use small drill bit to make pilot holes in each corner of the cut out area and then
use a jigsaw to cut along the inside edge of the cut out line.
6. Ensure that the display fits into the removed area.
7. File around any rough edges.
8. Drill the fixing holes as indicated on the mounting template.
9. Peel the backing off of the panel mounting gasket and place the adhesive side of the gasket onto
the back of the display and press firmly onto the flange.
10. Connect the SeaTalkng ® cable.
11. Position the display in place and secure using the fixings provided.
12. Refit buttonpad and bezel.
Note:
• Drill bit, tap size and tightening torques are dependant upon the material type and thickness of
the mounting surface.
• The supplied gasket provides a seal between the unit and a suitably flat and stiff mounting
surface or binnacle. The gasket should be used in all installations. If the mounting surface or
binnacle is not entirely flat and stiff or has a rough surface finish ,it may also be necessary to
use a marine-grade sealant.
23
