WARNING: Navigation aid
Although this product has been
designed to be accurate and reliable,
many factors can affect its
performance. As a result, it should only
be used as an aid to navigation and
should never replace common sense and
navigational judgement. Always
maintain a permanent watch so you can
respond to situations as they develop.
WARNING: Cable
Do not disconnect the keyboard cable
from the keyboard.
WARNING: Product installation
This equipment must be installed and
operated in accordance with the
instructions contained in this handbook.
Failure to do so could result in poor
product performance, personal injury
and/or damage to your boat.
WARNING: Electrical safety
Make sure the power supply is switched
off before you make any electrical
connections.
Gasket
Template
Whats in the box?. . . .
D7701-1
Safety notices
Terminator (x2)
SeaTalk
2
power/RF ground cable (1.5m)
SeaTalk
2
cable (1.5m)
SeaTalk
2
Keyboard
5-way junction box
Drain tube (8mm x 1m)
Suncover
Clamp (x2)
Stud (x2)
Thumb nut (x2)
Cradle
Handbook
Subject Page
Introduction 1
The controls
2
What's in the box?
3
Safety notices
3
Planning the installation
4
Integrating the Remote Station Kit
6
Installation 7
Spares and accessories
9
Removing/refitting 10
Maintenance 10
Important information
11
Technical support and contact details
12
D7679-1
Contents
Introduction to the SeaTalk
2
Keyboard
This handbook explains how to install, connect, operate and maintain your SeaTalk
2
Keyboard (E55061). This keyboard is also supplied with the Remote Station Kit (T82005) -
details of how to integrate these devices is given on Page 6.
Intended use
This product is a keyboard intended for use within a SeaTalk
2
system and connected via a
junction box to Raymarine's E-Series display. The intended application is for leisure marine
boats and workboats not covered by IMO/SOLAS carriage requirements. The SeaTalk
2
keyboard is waterproof to CFR-46 standard.
www.raymarine.com
SeaTalk
2
Keyboard
Owner's Handbook
1
MENU
WPTS
MOB
DATA
ACTIVE
PAGE
OK
CANCEL
IN
OUT
.
3
