Raymarine E12093, Installation Instructions Manual

Page: 25 / 40

23
Setting-up the
system
When you have installed the system, you need to check that the
system is wired correctly and set up to suit your type of boat.
This chapter provide instructions for the following post-installation
procedures:
Functional test
Switch on
1. When you have installed your autopilot system, switch
on the main power breaker.
2. If the control unit is active and the system operating, the control
unit will beep and display the pilot type (
Wheel
or
Tiller
).
CAUTION: Wheel drive systems
One second after power-on the wheel pilot will drive to starboard
for three seconds. This is to allow even wear on the drive belt.
3. After displaying the pilot type for two seconds, the control unit
will then display the
Standby
screen.
81131_8.book Page 77 Thursday, October 7, 2004 11:03 AM