3.5 Tools required
The following tools are required to install the
transducer.
2
1
4
5
6
7
3
D12951-1
1
Angle finder
2
File
3
*Marine grade adhesive sealant (suitable for
submerged applications)
4
Drill bit (for drilling the pilot hole)
5
Adjustable spanner (suitable size for the
transducer nut)
6
Band saw (for cutting the Dead rise block)
7
32 mm (1 1/4 in) hole cutter
Important:
*It is the installers responsibility to ensure correct
installation. Before installing the transducer please
check the sealant manufacturer’s guidelines
to ensure it is suitable for use in the intended
environment and with the materials used in the
transducer and your vessel’s hull.
Raymarine accepts no liability for damage caused
due to the use of unsuitable materials.
3.6 Warnings and cautions
Important:
Before proceeding, ensure that you
have read and understood the warnings and
cautions provided in the
Chapter 1 Important
information
section of this document.
16
CPT-70 / CPT-80 / CPT-110 / CPT-120
Summary of Contents for DownVision CPT-70
