Raymarine CP100, Installation Instructions Manual

Page: 33 / 48

6.5 LED indications
The power LED for this product has a number of flashing (blinking) modes to provide status information for diagnostics and
troubleshooting.
LED color LED code Status User action
Solid Green Power On • None (normal power up takes <1 minute.)
Green 1 blink Normal operation • None
Amber 1
blink Transducer
disconnected • Ensure transducer cable and connections are secure and
free from damage.
• Power cycle unit to recover transducer information.
• If problem persists contact Raymarine technical support.
Amber 2
blinks No network
detected • Ensure network is powered.
• Ensure network cable and connections are secure and free
from damage.
• If problem persists contact Raymarine technical support.
Amber 5
blinks Under voltage
(<10.2V) • Ensure power cable and connections are secure and free
from damage.
• Ensure power supply cabling is consistent with
recommendations.
• If problem persists contact Raymarine technical support.
Amber 6
blinks
Over voltage
(>34.2V)
• Ensure power supply levels are consistent with
recommendations.
• If problem persists contact Raymarine technical support.
Red 1 blink General failure • If combined with voltage warning, check power supply and
cables.
• Power-cycle the unit.
• If problem persists contact Raymarine technical support.
Red 3 blinks Unit overheating • Ensure installation environment is within recommendations.
• Unit will stop pinging and then start again once normal
operating temperature is achieved.
• If problem persists contact Raymarine technical support.
Red 4 blinks Problems with
internal database • Power-cycle the unit.
• If problem persists contact Raymarine technical support.
Note: If any other LED sequence other than described above is seen and persists please contact Raymarine technical support.
System checks and troubleshooting
33