8. Click
[Properties]
.
9. Click
[Use the following IP address]
.
10. Enter the
[IP address]
so it matches the IP address of your product.
11. Change the
last three digits
of the IP address to a number between
1–254
(these digits must not match the IP address of the product or any
other device on the network).
12. Enter the
[Subnet mask]
255.255.255.0
13. Click
[OK]
.
You can now access the product by typing its IP address into one of the
supported browsers.
Note:
For further information on which browsers are supported, refer to the
following section:
Changing the IP address range on an Apple Mac PC
To configure the necessary IP address range settings on an Apple Mac PC,
follow the steps listed below:
Note:
You will need to know the IP address of your product for step 8. This can
be found by referring to one of the following sections:
•
p.47 — Accessing the camera’s IP address via ONVIF Device Manager
•
p.48 — Accessing the camera's IP address via a Raymarine® MFD
1. Click the
[Apple menu]
2. Click
[System Preferences]
3. Click
[Network]
4. Select the
[network]
the product is communicating on from the sidebar
5. Click
[Advanced]
6. Click
[TCP/IP]
7. From the
[Configure IPv4]
menu, select
[Manually]
8. Enter the
[IP address]
so it matches the IP address of your product.
9. Change the
last three digits
of the IP address to a number between
1–254
(these digits must not match the IP address of the product or any
other device on the network).
10. Enter the
[Subnet mask]
255.255.255.0
11. Click
[OK]
You can now access the product by typing its IP address into one of the
supported browsers.
Camera setup and operation via Windows 10 or Apple Mac PC
49
