4. Select your Wireless speaker from the list.
The Wireless handset will now pair with the Wireless speaker.
5. Select
OK
.
The Wireless handset’s audio will now be heard through the
Wireless speaker.
Note:
• You can only output audio to 1 speaker from the same
handset.
• If the pairing is unsuccessful, power the wireless speaker off
and then back on again and repeat the process.
Disconnecting a Wireless speaker
To disconnect your Wireless speaker from the Wireless handset
follow the steps below:
With the speaker connected to the handset:
1. Press the
Pairing
button on the front of the speaker.
2. Once disconnected the speaker can be connected to any
Wireless handset by following the
speaker to the wireless handset
procedure.
Wireless handset charging
When inserted into the wireless handset charging holster the
wireless handset will be charged using inductive charging.
Attention
Ensure your wireless handset is fully charged before use.
Charging
Whilst charging a battery symbol will gradually
fill up.
Charged
When fully charged the battery symbol will be
full.
With the Handset powered on the battery symbol will be displayed
in the status bar at the top of the screen.
With the handset powered off the battery symbol is displayed
fullscreen.
Handset controls
Overview of wireless handset controls.
1.
Power
— Press to power the handset on. Press and hold for
3 seconds to power the handset off. Momentary press to
access the shortcut list.
2.
PTT
(Push to Talk) — Press and hold to send a voice message.
Release to return to receive mode.
Note:
The maximum transmit time is limited to 5 minutes
to prevent unintentional transmissions from occupying the
VHF channel.
3.
Microphone location
4.
Channel Up
and
Channel Down
— Changes to the next or
previous VHF channel, also used to select or adjust options
in the menu.
5.
LCD display
6.
Back
— Go to the previous menu / screen. Press and hold
to return to the Homescreen.
7.
OK / menu button
— Press button to access menu / DSC
functions and to confirm selections.
8.
16 / +
— When powered on press to switch between priority
channels.
9.
HI/LO
— Press to switch between High (25 W) and Low (1 W)
transmit power.
10.
DISTRESS
— Lift up the spring-loaded cover and press this
button to make a DSC distress call.
11.
Volume Up
and
Volume Down
— Press to adjust volume or
squelch intensity up or down.
12.
Built-in speaker
13.
VOL/SQ
— Press button to switch between volume and
squelch controls.
Powering the handset
To power the Handset on and off follow the steps below.
With the Base station powered On:
Wireless handset and charging holster installation instructions
3
