www.Busse-Yachtshop.de - [email protected]
34
A-Series display - Installation instructions
To re-assemble the bracket:
1. Pass the power cable and if applicable, the sonar and SeaTalk
ng
cables through the centre hole of the mounting bracket and the
locking ring.
2. Place the mounting bracket in position on the base plate, using
the locating lugs to ensure that it is at the correct angle. The
locking mechanism should be on the right-hand side of the
bracket when installed.
3. Refit the locking ring and rotate clockwise to secure it in position.
4. Refit the screws to secure the locking ring in position.
5. Pass the cable(s) through the centre hole of the cable seal and
place the seal in position, ensuring that the cable channels
locate at the rear of the mounting bracket.
6. Place the cable(s) into the cable channels and secure them by
refitting the base cover and securing it in place using the four
screws. Make sure that you leave enough cable to allow connec-
tion the rear of the display unit.
D11352-1
D11353-1
Summary of Contents for A Series A50
