D1
1531-1
Two buttons at the right-hand side of the front panel are used with
some setup procedures to provide
BACK
and
ENTER
functions.
The ACU rear connectors are:
•
DC 9 to 30V
for power input.
•
ANT RF1
- connects power and signal to the antenna.
•
NMEA
- connects to GPS (optional).
•
PC INTERFACE
- connects to PC serial port for remote operation
from a computer (optional).
•
RECEIVER
- connects to the satellite receiver (not supplied).
ANT
RF1
FUSE
DC 9 to 30V
NMEA
PC INTERF
ACE
RECEIVER
-
+
-
+
MADE IN KOREA
D1
1542-2
For connection details, refer to the installation procedures.
Using GPS with STV
Your STV system can make use of GPS to improve the DVB signal
tracking accuracy.
•
37 and 60 STV Gen2 models
– These have a built in GPS
receiver for improved tracking accuracy.
•
45 STV
– This can be connected to an NMEA 0183 compatible
GPS receiver using the connector provided.
NMEA
connector
D1
17
26
_1
Connecting STV to NMEA 0183 GPS
With the system powered OFF, connect an NMEA feed to the ACU
for GPS positioning information, refer to the following illustration
for reference:
Red (12 - 32 V /+)
Yellow (NMEA out /+)
Brown (RTCM in /+)
Green (NMEA in /+)
Shield (0V/ ground / -)
GPS antenna
cable
Connector
block
GPS antenna
cable
Additional cable
Pin 1
Pin 2
D1
17
25
_1
1. At a suitable point, cut your GPS antenna cable.
2. Strip each wire in the GPS and additional cable ready for the
connector block.
3. Connect stripped GPS wires to the connector block, matching
the wires on either side.
14
STV Gen2 installation and operation