33
Action
Required
Step1 :
LHS Button
Step 2 :
RHS Button
LHS
LED
RHS
LED
Comment
Disable /
Enable
Manual
Buttons
1 x Long
Push (4s)
and 2 x short
Push
Push to
cycle
Disable /
Enable
Flashing
Amber
Disable – Red
Enable - Green
Buttons will be
Disabled 30
minutes after
this selection is
made – This is to
allow the user
to re-enable
manual buttons
if required
Full Re-set
(including PIN
re-set)
Keep both
buttons
depressed
during
power up –
LEDs will
both flash
Amber
Keep both
buttons
depressed
during
power up –
LEDs will
both flash
Amber
Illuminator will
revert to
Programming
Mode, Full
factory default
including No
PIN
The illuminator has two modes; (1) Programming Mode when the remote
control can be used and (2) Operating Mode when most of the remote
control functions are disabled (see Remote Control Instructions for more
details
Manual Buttons are always available in programming mode or if they have
been disabled, they can be enabled in programming mode.
Manual Buttons are available in operating mode, provided they have not
already been disabled.
The number of button pushes indicated above are based on the user
starting with the illuminator in either programming or operating mode.
If the user has already started to program the units, then the number of
button pushes on the left hand will take them to the next function as per the
sequence in the table.
If no buttons are pressed within 2 minutes then the illuminator will
automatically default back into the previous mode it was in – programming
or operating mode.
www.ray
led
.com
Ray
LED
Tel : +
33
(0)
4 58 00 15 74
