29
Step 3 : LED Indicators
Check the LED status indicators for the status of the illuminator. The LED
indicators will display differently depending on which mode the illuminator is
in (see below)
Programming mode
– (RHS LED flashes AMBER 1 second on/1 second off)
LHS SOLID GREEN:
Power Applied
LHS FLASHING GREEN:
Remote control IR receiver problem
RHS FLASHING AMBER: Indicates unit is in programming mode
RHS SOLID AMBER:
Indicates that a valid command is being received
LHS FLASHING RED:
Voltage supply problem detected
LHS SOLID RED:
Illuminator fault detected
Note: the if there is a voltage supply error, the LHS RED LED will FLASH RED
but extinguish and revert to the standard SOLD GREEN when the correct
voltage has been restored.
The fault indications are non latching
Normal operating mode
LHS SOLID GREEN:
Power Applied
LHS FLASHING GREEN:
Remote control IR received problem (Max VRC
distance is 8m (26ft)
LHS FLASHING RED:
Voltage supply problem detected
LHS SOLID RED:
Illuminator LED fault detected
•
Check unit is responding to Remote /Manual Control buttons.
If not..
-
Status indicators may be turned off. Turn on with remote or with manual
buttons. This can be done even if programming has been disabled
-
In extreme sunlight conditions, distance between remote and unit may
need to be reduced
-
Programming may be disabled. Enter PIN to retrieve control or RESET
illuminator using one of the two RESET modes.
www.ray
led
.com
Ray
LED
Tel : +
33
(0)
4 58 00 15 74
