15
If legal characters but not the correct sequence of characters are
entered the number of flashes will still reduce and after 4 characters
have been entered an error will be shown by both LED`s flashing RED.
If an illegal character is used when entering a pin, it will be ignored and
the PIN character count will not reduce. The process to enter a PIN will
have to be repeated.
Deleting a PIN
To delete a PIN you first need to be in Programming Mode. Press STATUS
BUTTON for 4 seconds to go into PIN set mode. LHS LED will flash RED /
GREEN. RHS LED FLASHING RED. Instead of entering one of the known
legal characters press the RESET BUTTON four times. The illuminator will
return to programming mode.
*Note – if you delete the PIN and then use your remote or manual push
buttons to put your illuminator into operating mode, you will not be able
to go back to programming mode without recycling the power.
*Note - If you forget your PIN and need to make adjustments to the
illuminator you will need to perform a full Re-set. This requires power
recycling whilst pressing the two manual control buttons at the same
time. This will restore factory default settings AND remove the previously
programmed PIN. Both LEDs will flash AMBER to signify that the process
has been completed.
*Note – If you do not want to set a PIN, but want to prevent another
person with a remote setting a PIN, then you need to Disable both the
Remote and the Manual Push Buttons (See Manual Control Push Buttons
section – Page 16) The only way another user can then access the
illuminator is by performing a full re-set (see Page 23)
*Note – If you are trying to access a PIN in Operating Mode, hold the
status button down for 4 seconds and both LEDs flash RED, this means
there is no PIN present.
www.ray
led
.com
Ray
LED
Tel : +
33
(0)
4 58 00 15 74
