Wuhan Raycus Fiber Laser Technologies Co., Ltd
User Guide of 1500W CW laser
First Step: Open Raycus PC software
，
click “
Session
→
RS232(or Ethernet)
”to
make the host computer communicate with the laser, and then click "
Tool
→
Laser IP Set
" to enter the laser IP address setting;
Second Step:The default password is "1122334455667788". After passing the
verification, read or set a new laser IP address.
Third Step: If you use the upper computer software of Raycus to control the
laser, you need to find the folder where the upper computer software is located,
open the laser configuration file config.xml, and write the newly set IP address of
the laser; if you do not use the upper computer of Raycus, please directly enter the
fourth step;
Fourth Step: Configure the Ethernet network connection on the PC side, select
"Use the following IP address:", and manually assign the IP address. The PC side
IP address must be on the same network segment as the laser IP address, and
assign a subnet mask address. The default is 255.255.255.0. Click the "OK" button
to confirm the settings and exit.
26
