3
25.400
25.400
(
figure 1
）
(
figure 2
）
(
figure 3
）
1. Use screwdriver to open the battery cover
(
figure 1
)
2. Base on the instruction in the battery slot to
put battery
(
figure 2
)
3. Tighten the screws in battery cover
(
figure 3
)
Front
back
bladeA
bladeA
bladeB
bladeB
Remote control installation instructions:
Blade installaction location:
Protection cover installation instructions:
Frequency connect/Unlock:
Power
switch
1. “Front”“Back”as the right figure, Place quadcopter on
level ground, put quadcopter’s head in front. Back aim
at transmitter
.
2. Turn on the botton prower switch, quadcopter’s light flash
.
3. Open the transmitter switch, push the throttle stick,
then pull down the throttle stick, the transmitter’s indicator
light will be stable, the quadcopter’s light also stable,
it means frequency connect sucessfully
.
4. Following figures shows three ways unlock. Four paddles
will be rotate slowly when quadcopter unlock, it means unlock sucessfully.
Noted
:
After unlock, if do not do any operation, about 10 seconds, motor will be stop
automatically. If need to quick stop after start, just re-do unlock operation.
Throttle/Rudder
(turn)
Throttle/Rudder
(turn)
One key unlock/landing
Front/back/Left /
right side fly rudder
Front/back/Left /
right side fly rudder
Base on figure to install protection cover, and use screw to fix it.
Front
back
Power
switch
