Rayco C275, Operator, Service, Maintenance Manual

Page: 24 / 94

C275 Operation & Service Manual
24
Pre-Start Procedure
Walk-Around Inspection
For maximum service life of the machine, make a thorough
walk-around inspection. Inspect the machine for the following:
• Loose bolts
• Trash buildup
• Oil leaks
• Broken parts
• Worn parts
Inspect the overall condition of the machine and its hydraulic
components.
Check the engine oil level, the hydraulic oil level, and the
fuel level.
Refer to the
Maintenance Interval Schedule for all service
recommendations.
Mounting and Dismounting
• Get on or off the machine only at locations that are
equipped with steps and/or hand holds.
• Before you get on the machine, clean and inspect the
steps and the hand holds. Make all necessary repairs.
• Face the machine whenever you get on or off the machine.
• Maintain a three-point contact with the steps and
hand holds.
Note: Three-point contact can be two feet and one hand, or
one foot and two hands.
• Do not get on or off a moving machine.
• Never jump off the machine.
• Do not try to get on or off the machine if you are carrying
tools or supplies. Use a hand line to pull equipment
onto the platform.
• Do not use any controls as hand holds when you enter
or exit the operator’s compartment.
Seat and Seat Belt Inspection
Adjust the seat at the beginning of each work period. Also
adjust the seat when you are changing operators.
Inspect the seat belt mounting hardware. Replace any
hardware that is damaged or worn. Keep the mounting
bolts tight.
Fasten the seat belt before you start the engine.
Emergency Exit
Familiarize yourself with the alternate exit. In the event that
the primary exit is blocked, the top window hatch may be
removed. This hatch is accessible from inside or outside
the cab. The escape hatch is fastened with 3 knobs located
directly above the operator seat.
Rollover Protective Structure (ROPS)
• To avoid the possible weakening of the ROPS/FOPS
structure, do not alter the structure by welding, cutting,
adding weight, or drilling holes into the structure.
• Do not mount fire extinguishers, first aid kits, lights or other
items to the ROPS/FOPS structure. Welding brackets
or drilling holes in the ROPS/FOPS can weaken the
structure. See your Rayco dealer for mounting guidelines.
• Any alteration that is not specifically authorized by Rayco
invalidates the certification for the ROPS/FOPS. The
protection that is offered by the ROPS/FOPS will be
impaired if the ROPS/FOPS has structural damage.
Damage to the structure can be caused by an overturn,
falling objects, etc.
• Use of the ROPS/FOPS in a damaged, modified or
abused condition, or with a prior overturn, is unsafe
and the operator protection is no longer suitable and
must be replaced.
Operation
steps to access cab
Unscrew Knobs to remove top hatch (emergency exit)