• This rack is intended for use with tools and bikes only. Do not attempt to
mount other objects/persons on the rack.
• The screws supplied with this tool and bike rack are intended for use with
brick and/or concrete walls only.
• Always use appropriate care when working with mounting hardware
and
tools.
• Do not overload the rack or else it may damage the product and/or the
mounting
surface.
A Note on Fasteners
While standard fasteners and anchors intended for use with concrete and/or
brick walls are included with this storage rack, it remains the responsibility of
the person installing the storage rack to determine which fastener type should
be used for each speci
fi
c installation and/or type of substrate. Please ensure
that appropriate pullout tests are performed prior to installation.
If you are unsure about what type of mounting hardware you should use, please
ask a professional for assistance.
In no event shall RaxGo
™
be liable for any direct, special, punitive, exemplary,
indirect, or consequential damages resulting from improper installation, misuse,
and/or use of the product beyond its limitations and/or intended purpose.
This includes, without limitations, overloading of the product and/or use of
the product under extreme or abnormal conditions, either intentionally or
as a result of user error.
1. Package Contents
2. Safety Precautions
Tools Required:
• Impact Drill (with 10 mm Drill Bit)
• Hexagon Head Screwdriver
NOTE:
The two racks included may be used together or separately.
1. Slide a bracket on to the rail to create a template rack for placement. Place
your template rack in the desired location and mark the holes on the wall.
(Make sure to locate the studs in the wall if applicable, e.g., if installing
on
drywall.)
NOTE:
The eight (8) black hex nuts should come connected to the eight (8)
M6 x 50 mm screws. Simply unscrew the hex nuts to separate them.
2. Drill holes with the impact drill using a 10 mm drill bit at the marked points
(about 60 mm deep). Place wall anchors inside drilled holes. Then insert
four (4) of the M6 x 60 mm screws through the bracket into the wall
anchors and use your hexagon head screwdriver to screw them in place.
NOTE:
If you are installing the rack to a
wood wall or into studs,
use your hexagon head screwdriver to screw four (4) of the M6 x 60 mm
screws through the bracket at the marked points on the wall. (Wall anchors
are
not needed for wood walls and studs
.)
3. Line up the holes of the bracket and the holes of the rail. Next, place the
M6 x 50 mm screws in the aligned holes. Then, tighten the nuts on the
other end of the screw to stabilize rail.
4. Slide the desired hooks onto the rail from the open end.
5. Slide the second bracket onto the other end of the rail. Insert another
two (2) M6 x 50 mm screws through the holes of the bracket and rail
then tighten with the nuts. Finally, insert the four (4) M6 x 60 mm
screws into the bracket and screw into the wall.
6. Repeat the process in a di
ff
erent desired location for the second rack.
(Again, note that you can combine the rails together by lining up the
holes if desired.)
600 mm Rails (2)
Tool Hooks (4)
Wall Anchors (16)
Hex Nuts (8)
User Guide
3. Installation Instructions
Brackets (4)
Bike Hooks (2)
M6 x 50 mm
Screws (8)
M6 x 60 mm
Screws (16)
