Space Invaders Frenzy™
38
|
P a g e
Problem
Possible Cause
Solution
Entire module malfunctioning.
Faulty data transmission.
Check ribbon cable between
malfunctioning module and
module to the left (from the
back).
Check/replace module to the left
(from the back).
If module is left-most in quadrant
(from the back):
•
Check ribbon cable
between module and
LED display controller.
•
Check quadrant LED
display controller.
Bad power.
Check power connection to LED
module.
Check quadrant fuse block for
blown fuse.
Screen Note 1
: Space Invaders Frenzy uses over 65,000 LEDs on its giant screen. It is normal for a few LEDs to
fail over the course of operating the game. This will not affect normal operation or viewing of the game and
most will not be noticeable to the eye.
Screen Note 2
: This manual is accompanied by a separate document: “LED Display (P7.62 Version) Full
Assembly and Service Procedure”. Please refer to this document when servicing and troubleshooting the LED
display. Additional information regarding the latest version of software and documents can also be found on
our website:
Screen Note 3
: If the ethernet cable is plugged into the incorrect port, it can cause errors to occur. Make sure
that the USB cable is plugged in and the ethernet cable is plugged into the "U" port. See diagram below:
Summary of Contents for Space Invaders Frenzy
