Raven SmarTrax Case IH Titan 4030, Installation Manual

Page: 25 / 44

4
Manual No. 016-4001-127 Rev. B 21
Cab Component Installation
FIGURE 8.
Convenience Tray Removed
13.
Remove the convenience tray from the right-rear corner of the cab.
14.
Locate the connectors labeled POWER GND PORT and PRODUCT CAN on the machine’s harness in the
convenience tray compartment.
15.
Connect the machine’s POWER GND PORT connector to the mating 6-pin POWER connector on the node
harness.
16.
Remove the dust cap from the 4-pin PRODUCT CAN connector on the machine’s harness and connect it to
the mating 4-pin CAN connector on the node harness.
FIGURE 9.
DGPS OUT Connected to Console Receiver Connection
17.
Connect the DGPS connector on the node harness to the GPS receiver.
18.
Route the DGPS OUT connector on the node harness to the A-post at the front-right corner of the cab.
19.
Connect the DGPS OUT connector to the Viper Pro or Envizio Pro receiver connection.
Console
Cable
Console Receiver
Connection
DGPS Out
(Node Cable
Connection)