C
HAPTER
4
16
Raven RS1™ HDU Installation Manual for Case IH Patriot 3XX0 (Steering Ready, Model Year 2010-2016)
FIGURE 6. SC1 Node Mounting Location
3. Remove the Auxiliary power port.
4. Mount the node and bracket assembly to the floor of the cab, underneath the cab floor plate using the four
holes use to mount the auxiliary power port.
NOTE:
It may be necessary to drill the holes out to install the SC1 mounting bracket.
5. Reinstall the auxiliary power port on the studs of the SC1 mounting bracket, utilizing the nuts provided in the
kit.
NOTE:
The SC1 node must be mounted in a horizontal orientation. Ensure that the direction of the node is
recorded, as this information will be required to complete calibration of the SC1 system.
INSTALL THE CAN BRIDGE CABLE - IF APPLICABLE
FIGURE 7. CAN Bridge Cable Connected to HDU Harness Cable
1. Remove the terminator from the 4-pin connector next to the Viper 4 connection of the HDU harness cable
(P/N 115-4010-026).
2. Install one end of the CAN bridge cable (P/N 107-0172-458) on the 4-pin connector.
