C
HAPTER
3
8
Raven RS1™ HDU Installation Manual for Case IH Patriot 3XX0 (Steering Ready, Model Year 2010-2016)
FIGURE 3. Small WAS Mounting Bracket Installed on Rod-End of Steering Cylinder
3. Remove the nuts and clamp from the 1-1/4” U-bolt clamp (P/N 435-3003-056).
4. Install the U-bolt clamp on the threaded rod-end of the right steering cylinder adjacent to the existing jam nut,
positioning the U-bolt so that the threaded ends point upward.
5. Tighten the nuts to secure the U-bolt clamp in place.
6. Install 5/16” washers (P/N 313-2301-005) on the ends of the U-bolt clamp.
7. Insert one of the M10 x 1.5 x 40 metric hex bolts (P/N 311-00470-025) through the center hole of the small WAS
mounting bracket (P/N 107-0172-030).
8. Install the small WAS mounting bracket on the ends of the U-bolt clamp so that the installed hex bolt points
upward.
9. Install one 5/16” flat washer (P/N 313-2301-005) and one 5/16”-18 nylon insert lock nut (P/N 312-4000-059) on
the each end of the U-bolt clamp to secure the small WAS mounting bracket.
10. Tighten the nuts to ensure the small WAS mounting bracket is installed securely.
11. Install a 0.406” ID x 0.750” OD x 0.375” long spacer (P/N 107-0172-037) on the end of the protruding hex bolt.
