Chapter 2
Note:
If studs are broken, the factory power relay module will need to be
replaced.
7. Secure the battery cable using the supplied zip ties and replace the rear cover.
Base Cable Power Connection
CAUTION
Do not connect the system power cable to the vehicle ignition or
battery until all system components are mounted and all
electrical connections are completed.
1. Locate and access the battery compartment below the left side of the cab. It may be
necessary to remove the tool box or battery cover.
2. Use a 10 mm socket to remove the two nuts holding the black cover over the electrical
components and power hook ups.
CAUTION
Corrosion and build up on the power relay module may
make connecting OMNiDRIVE™ leads difficult. Use
penetrating oil on studs and nuts before attempting to
connect leads to the module. If studs are broken, the
factory power relay module will need to be replaced.
140
Summary of Contents for OMNiDRIVE
