6
Installing controller into Chillin’ Glow Float Tube
1. Inflate tube first.
2. Plug the two ends of the connector
together.
IMPORTANT: Ensure the connector latch is
secured. The LED’s will not function if this
connection is not done correctly.
3. Orient the controller so that the locking
screw and tab on the controller are lined
up with the nut and tab receiver on the
base cup.
4. Insert tab end of the controller into the
slot on the base cup.
5. Press down to compress the seal and
tighten the locking screw.
IMPORTANT
: It is critical that this
locking screw be tightened to ensure a
water-tight seal. Pull up on the control
head to ensure it is solidly locked in
place and the seals are fully engaged.
Ensure the wire harness is oriented
in this corner of the base cup.
