Instruction manual
RAVAGLIOLI S.p.A.
RAVTD1760 WS – RAVTD1780 WS
Code M0197 - rev.1.0
(11/2010)
Page 28/52
RAVAGLIOLI S.p.A. -
Via I° Maggio, n° 3 (Pontecchio Marconi)
40037 Sasso Marconi (Bologna - Italy)
Tel. 051/ 67.81.511 – Fax 051/ 84.64.67 E-mail: [email protected]
As soon as vehicle matches target point, wait for detectors to stop oscillating. “STOP” will be
displayed for approx. three seconds, which are enough for the programme to acquire
measurement readings. Then the following screen will be displayed:
Figure 35
Move vehicle forward again, until the rotation of the wheel did not make back 30 degrees
forward (final point). “STOP” will be displayed for approx. three seconds, and measurement
readings acquired. The thrust Run-Out procedure has been completed.
Figure 36
Should you be willing to repeat the operation once the programme has already entered a
following phase, you can go back to this page by pressing F1, and repeat the above
procedure. Once the Run-Out procedure has been completed, programme will automatically
go to the next phase.
Vehicle thrust
direction
Vehicle
matches target
point
Vehicle target
point
