INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
Page 31 of 60
12.9 Tyre inflation with machine without
tubeless inflation
Connect the inflation device to the tyre valve and inflate
the tyre using the pedal provided (
Fig. 19 ref. 5
).
A SAFETY DEVICE IS PRESENT
FOR THE ADJUSTMENT OF THE
MAXIMUM PRESSURE OF THE
SUPPLIED AIR (4,2 ± 0,2 BAR /
60 PSI).
Well lubricated beads and rims make the beading in
and inflation much safer and easier.
In case the beads are not seated at 4.2 ± 0.2 bar,
release all the air from the wheel, remove it from the
tyre changer and put it in a safety cage to complete
the inflation procedure.
12.10 Tyre inflation with machine with tube-
less inflation
Some types of tyres can be difficultly inflated if the
beads are not in contact with the rim. The tubeless
inflation device supplies a jet of high-pressure air from
the nozzle, which encourages the correct positioning
of the bead against the rim, and therefore normal
inflation.
In order to carry out the inflation of the tyre follow
these indications:
• Connect the inflation terminal to the valve of the tyre.
• Press the nozzle against the rim edge.
• Lift the lower bead while the pedal, is pushed at its
second stage, supplying that way the air jet required
for bead insertion.
• Continue to inflate the tyre up to the required pres-
sure keeping the provided pedal pressed.
IN ORDER TO ALLOW THE AIR
JET TO BREAK BOTH BEADS,
DO NOT KEEP THE BEAD LIFTED
FORCING IT.
13.0 ROUTINE MAINTENANCE
BEFORE CARRYING OUT ANY ROU-
TINE MAINTENANCE PROCEDURE,
DISCONNECT THE MACHINE
FROM ITS POWER SUPPLY SOURC-
ES, TAKING SPECIAL CARE OF
THE ELECTRICAL PLUG/SOCKET
CONNECTION.
BEFORE CARRYING OUT ANY
MAINTENANCE OPERATIONS,
MAKE SURE THERE ARE NO
WHEELS CLAMPED ON THE MAN-
DREL AND THAT ALL SUPPLIES
TO THE MACHINE HAVE BEEN
DISCONNECTED.
To guarantee the efficiency and correct functioning
of the machine, it is essential to carry out daily or
weekly cleaning and weekly routine maintenance, as
described below.
Cleaning and routine maintenance must be conducted
by authorized personnel and according to the instruc-
tions given below.
• Disconnect the mains power supply before starting
any cleaning or routine maintenance operations.
• Remove deposits of tyre powder and other waste
materials with a vacuum cleaner.
DO NOT BLOW IT WITH COMPRESSED AIR.
• Do not use solvents to clean the oil/pressure regula-
tor.
• The condensation in the pressure regulator reser-
voir must be drained
daily
. Press the connector at
the bottom of the regulator to discharge the water.
(see
Fig. 55
).
• Periodically check the calibration of lubricator of
pressure/oiler gauge unit: 1 oil drop every 11-15
revolutions of self-centering chuck motor.
RAVAGLIOLI S.p.A.
7300-M018-2_R
G8945.26 - G8945IT.26 - G8945V.26 - G8945ITV.26 - G8945V.26S - G8945ITV.26S - G8945D.26 - G8945ITD.26 - G8945D.26S - G8945ITD.26S